Great performance and easy to handle for beginers
A: Yes, the platform has been sandblasted to make the platform rough and easier to stick to the model. When you find that the platform has been severely scratched, you can contact the sales staff to ask if it needs to be replaced.
A: First determine where the sound is. If it is the sound from the rail, it should be normal.
A: First confirm that the computer and the printer are in the same LAN, restart the router, and restart novamaker.
A: First check the WIFI selection interface, the signal value behind the wifi name, the recommended signal value range is -55dbm~0dbm, then try to restart the WIFI and connect to the printer WIFI again.
A: Nova3d does not recommend the use of resins with other wavelengths. Depending on the content and model of the photoinitiator used in the resin, it may not be cured, or it may take a long time to cure.
A: Yes, the resin can be used until it is cured. It needs to be filtered every time it is poured from the hopper to prevent small cured products from being in the resin, which may cause screen leakage during the next printing.
A:Yes, slightly toxic, please do not directly contact the material, it is recommended to wear cyanide gloves for operation.
A: There are two situations: 1. The second printing will not be performed next. It is recommended to filter the resin in the trough once and then pour it back into the resin bottle for storage. 2. Immediately perform the next printing. It is recommended to filter the resin in the trough before printing to prevent the solidified residue from crushing the screen in the trough.
A: Try to install the LCD screen several times. The most likely reason is that the screen cable is not installed properly.
A: This kind of problem is that the screen IC is damaged, which is within the scope of the screen warranty. You can directly ask the salesperson to reissue it (take a video of the screen test and send it to the salesperson).